Dial-up server: Setting up a virtual POTS infrastructure

directedition asked:

I have dial-up server and client software that I want to be able to test and script. Unfortunately, I don’t own a landline. Much less, multiple lines that I can use to test concurrent connections.

What I do have, is a handful of modems and a computer to plug them into. Is there any way that I could simulate a phone line in such a way? As in, actually be able to plug in a landline telephone in, get a dial tone, be able to dial a number, and route it to my software on the server?

I appologize if this is not the appropriate forum for this question. I’m afraid I have no idea where to start with this, or if what I’m attempting is entirely half-baked.

My answer:


OK, so back in the olden days what we did to simulate this was to connect two modems back-to-back via their telephone line ports and a phone line cord. Then we would disable dialtone detection on one modem and dial out with it, and then have the other modem “answer”. The two modems will happily talk to each other without an intervening telephone network, though you are limited to 33600 bps. You can’t auto-answer because there’s no telephone network and thus no ring signal.

If the modem is generally Hayes compatible, as virtually all modems are, it should be sufficient to “dial” with:

ATX0D

and answer with:

ATA

View the full question and answer on Server Fault.

Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 3.0 Unported License.